Surefire Custom E head Triple XP-G2 Warm White 90 CRI

작성일 2016.07.03

-----------------------------------------------------------------------------------------------------------------------------------------------------

Surefire E Head with Triple LED modification

Spec.

1. Surefire E head Hard Anodized

2. Triple Cree XP-G2 3000K 90 CRI

3. Carclo 10507 Clear Narrow Optic Lens

4. Astrolux S1 A17DD-L FET+1 Flashlight Driver Only for single li-ion battery. 

5. Tailcap measured current. 

   1) 3mA-15mA-136mA-464mA-759mA-1748mA-3526mA with LG HG2 3000mAh unprotected cell

   2) 2151mA with Sanyo 16650 2100mAh unprotected cell

6. 0.5㎟ Wire (AWG20)

7. Custom Copper Heatsink

8. Noctigon DTP Copper mcpcb

9. No waterproof

Driver UI (link)

  While off:

    - Fully click and release to turn the light on.  It will go to the 
      first mode or the last-used mode, depending on whether you enabled 
      mode memory.

  While on:

    - Short tap: Do a short (less than 0.5s) half-press to go forward to 
      the next mode.

    - Med tap: Do a medium (0.5s to 1.5s) half-press to go backward to 
      the previous mode.

    - Long tap: Do a long (longer than 1.5s) half-press to reset to the 
      first mode (if mode memory is turned off).

    - Or fully click and release to turn the light off.

  Hidden modes:

    - Go backward from moon to access the hidden modes.  They are, in 
      order:

      - Turbo (just like the regular turbo)

      - Tactical strobe (10 Hz)

      - Battery check / beacon mode
        (each blink represents about 25% of a full charge)
        0 blinks: < 1% full        (< 3.0V)
        1 blink : 1% to 25% full   (3.0V to 3.5V)
        2 blinks: 25% to 50% full  (3.5V to 3.8V)
        3 blinks: 50% to 75% full  (3.8V to 4.0V)
        4 blinks: 75% to 100% full (4.0V to 4.2V)
        5 blinks: > 100% full      (> 4.2V)

      - Biking flasher (2-level stutter beacon, 1 Hz)

  Configuration options:

    - Short tap rapidly a bunch of times (15+ taps, or until the light 
      stops turning on) to enter soft config mode.

      The way it works is the light will blink twice for each option, 
      then pause for a bit before moving to the next option.  Turn the 
      light off between the two blinks to toggle that option.

      The available options are:

      - Mode group: 7 modes or 4 modes:
        Group 1: moon, low, med1, med2, high1, high2, turbo
        Group 2:       low,      med,       high,     turbo

      - Mode memory toggle

    - If CONFIG_STARS is defined, you can ground pin 3 of the MCU to 
      enable mode memory instead of using config mode.  This can often 
      be done by soldering a star on the spring side of the driver, if 
      your driver supports that.  Otherwise, it's pretty easy to make a 
      solder bridge from pin 3 (mode mem toggle) to pin 4 (ground).  Or 
      even just wedge a piece of metal between the two pins.

  Other details to note:

    - Low-voltage protection will progressively step down the output at 
      about 2.8V, and the light will shut itself off when even the 
      lowest level gets below 2.8V.

    - The default turbo step-down is 45 seconds.

    - When turbo steps down to high, a short tap will push it back up to 
      turbo or a medium tap will step down further, even if you got to 
      turbo by going backward from moon.  The step-down effectively 
      moves it from the "hidden" turbo back to the non-hidden turbo.

    - A short tap from any hidden mode will return to the lowest mode.

보다 전류를 잘 통하도록 회로쪽 스프링에 전선을 하나 더 연결했습니다.

다만 테일캡을 어떤 것을 사용하느냐에 따라서도 흐르는 전류값을 달라집니다.

회로 UI

XP-G2 3000K

흔히 말하는 전구색 LED입니다.

가공하지 않는 E2e 바디에 헤드를 체결한 모습

다소 갭이 있습니다.

전류 측정 및 빔샷 테스트

먼저 LG HG2 3000mAh 비보호 배터리로 측정한 값입니다.

Mode 1

Mode 2

Mode 3

Mode 4

Mode 5

Mode 6

Mode 7

Turbo모드이며 30초 이후 절반정도로 줄어듭니다. 

실내빔샷 (거리 약 50cm, ISO 100, 태양광, 1/250s)

Mode 1 by LG HG2 3000mAh

Mode 2 by LG HG2 3000mAh

Mode 3 by LG HG2 3000mAh

Mode 4 by LG HG2 3000mAh

Mode 5 by LG HG2 3000mAh

Mode 6 by LG HG2 3000mAh

Mode 7 by LG HG2 3000mAh

실외빔샷 (거리 약 5m, ISO 100, 태양광, 1s)

Mode 5 by LG HG2 3000mAh

Mode 6 by LG HG2 3000mAh

Mode 7 by LG HG2 3000mAh

원거리빔샷

Mode 7 by LG HG2 3000mAh

다음은 Sanyo 16650 2100mA 비보호 배터리로 측정한 값입니다.

Mode 1~6 은 비슷해서 Turbo (Mode 7)값만 측정했습니다.

실내빔샷 (거리 약 50cm, ISO 100, 태양광, 1/250s)

Mode 1 by Sanyo 16650 2100mAh

Mode 2 by Sanyo 16650 2100mAh

Mode 3 by Sanyo 16650 2100mAh

Mode 4 by Sanyo 16650 2100mAh

Mode 5 by Sanyo 16650 2100mAh

Mode 6 by Sanyo 16650 2100mAh

Mode 7 by Sanyo 16650 2100mAh

실외빔샷 (거리 약 5m, ISO 100, 태양광, 1s)

Mode 5 by Sanyo 16650 2100mAh

Mode 6 by Sanyo 16650 2100mAh

Mode 7 by Sanyo 16650 2100mAh

원거리빔샷

Mode 7 by Sanyo 16650 2100mAh